2-door NOTE: Moonroof calibration is required if any of the conditions listed occur:
The ignition switch is turned OFF while operating the moonroof (pressing the open/close switch). As a countermeasure, if the ignition switch is returned to the ON (II) position within 10 minutes, and moonroof operation is continued, calibration will not necessary.
NOTE: If a door is opened during the 10 minutes period, the calibration will be required.
The moonroof is manually operated using the moonroof wrench with the battery dead or disconnected.
The moonroof motor is replaced with a new one.
The moonroof motor is removed from the moonroof assembly and operated before it is reinstalled.
Moonroof glass is positioned in the OPEN position (or partially open) Press the moonroof OPEN switch until the moonroof stops in its fully open position.
Release the moonroof OPEN switch.
Press the moonroof OPEN switch again for about 13 seconds.
NOTE: Keep pressing the switch even through the moonroof motor continues to function.
Calibration is complete. The moonroof will automatically move to the regular preset fully open position and come to stop.
Moonroof glass is positioned in the TILT position Press the moonroof OPEN switch until the moonroof glass stops in its fully open position.
Release the moonroof OPEN switch.
Press the moonroof OPEN switch for about 13 seconds.
NOTE: Keep pressing the switch even through the moonroof glass will repeat an inching behavior (moving 40 mm, then stopping for 0.4 seconds)
Calibration is complete. The moonroof will automatically move to the regular preset fully open position and come to stop.
